4 Getting started
The display shows all-track sync with
finalization, with the
and
SYNC
indicators blinking to show that
FINALIZE
recording can start.
Note: If You want to record CD text
information as well, press
after
NAME
pressing
. The
SYNCHRO
CD TEXT
indicator will light.
4
Play the source.
Recording starts automatically.
If you press
during recording,
SYNCHRO
the recorder will finish recording without
finalizing the CD-R.
5
After recording all tracks on the
source, the recorder starts
finalizing the disc.
After the recorder encounters about five
seconds of continuous silence, it assumes
the end of the source has been reached and
goes into all-sync record-pause.
Be careful: If the recorder detects
another signal or start ID (DAT or DCC) it
will start recording again!
If the recorder detects no signal for one
minute, finalization starts (no more
recording is possible after this so make
sure that there aren’t any spaces of more
than one minute during the source you’re
recording). See Automatically number-
ing tracks on page 33 to set the silence
threshold.
Finalization takes about two minutes,
during which time none of the buttons are
operative.
Never turn the power off during finaliza-
tion!
• If a digital signal is interrupted, the
recorder continues recording. However,
if no signal has been detected within
five seconds, the recorder pauses
recording and will not finalize the
disc—see Digital signal interruptions
on page 18.
• If the recorder reaches the end of the
disc, the recorder begins finalization.
Note: If you find that synchro recording
does not seem to work, see the trouble-
shooting section on pages 40–42 for
possible remedies.
21
En