Install Vent Pipe, Burnham Gasket-Less & Gasketed Vent System; Burnham Gasket-Less Male And Gasketed Female Vent Joint Detail; Burnham Gasket-Less Female And Gasketed Male Vent Joint Detail - Burnham Revolution Installation, Operating And Service Instructions

c. Tighten locking band by HAND with a 5/16" nut driver until snug plus ¼ turn. DO NOT SECURE JOINTS WITH
SHEET METAL SCREWS OR POP RIVETS. DO NOT PUNCTURE THE VENT SYSTEM!
d. Once the installation is complete, operate appliance and inspect all joints to ensure that flue gases and/or liquid conden-
sate will not escape.
E. Install Vent Pipe, Burnham Gasket-Less & Gasketed Vent System.
1. Procedure for joining the male end of Burnham Gasket-Less Vent with the female end of Burnham Gasketed Vent. See
Figure 3C.
Figure 3C: Burnham Gasket-Less Male and Gasketed Female Vent Joint Detail
a. Clean the male end of each joint using an alcohol pad to remove any dirt and grease.
b. Apply a continuous ¼ inch bead of sealant around male end of joint no more than 1/8 inch from end.
c. Align weld seams in pipes and use a slight twisting motion to FULLY insert male end into female end of joint. Ensure
bead in male end of pipe is below locking band and rest against the end of the female pipe. Verify the factory-installed
gasket is not dislodged or cut.
d. Smooth sealant around joint for a continuous seal. Reapply sealant if necessary.
e. Tighten locking band by HAND with a 5/16" nut driver until snug plus ¼ turn. DO NOT SECURE JOINTS WITH
SHEET METAL SCREWS OR POP RIVETS. DO NOT PUNCTURE THE VENT SYSTEM!
f. Once the installation is complete, operate appliance and inspect all joints to ensure that flue gases and/or liquid
condensate will not escape.
2. Procedure for joining the female end of Burnham Gasket-Less Vent with the male end of Burnham Gasketed Vent. See
Figure 3D.
Figure 3D: Burnham Gasket-Less Female and Gasketed Male Vent Joint Detail
13