Connect Your Wlan Adaptor; Configure Your Network; Creating Or Rejoining A Network - Philips LaserMFD LFF 6080 User Manual

LFF6080
You can be sure of perfect
communication if you use an
approved adaptor in conjunction with
your PC.
Note
All of the latest printer drivers for the
approved adaptor may be found on
our website together with further
information:
www.sagem-communications.com.

Connect your WLAN adaptor

Your machine belongs to a new generation of terminals
that you can incorporate into a WLAN network using a
WLAN USB key.
Your machine's network radio
adaptor transmits data using the
radio protocol IEEE 802.11g; it can
also be incorporated into an existing
IEEE 802.11b network.
When connecting to your machine,
only use the approved adaptor.
Other transmitting or receiving
Important adaptors may damage your device.
Irrespective of whether you use your
machine in an infrastructure or ad-
hoc network, you must set up certain
network and security parameters
(for example, the Service-Set-ID
(SSID) and the encryption key).
These must match the network's
specifications.
1 Plug your WLAN USB key into the USB port of your
machine.
Downloaded From ManualsPrinter.com Manuals

Configure your network

We recommend that the settings of
your WLAN network should only be
Note changed by a person with a good
knowledge of the configuration of your
computer.

Creating or rejoining a network

Before attempting to use a WLAN adaptor on your
machine, you must enter the parameters that will allow a
WLAN network to recognise your machine.
On your machine you will find simple instructions
that guide you step by step through the set-up of your
network. Just follow them!
This menu is only accessible when the
Note local network is set to WLAN (menu
26).
281 - SETUP / WLAN / CONFIG. ASS.
1 Type in , select the menu SETUP using the keys
or and confirm with OK.
2 Select WLAN using the keys
with OK.
3 Select CONFIG. ASS. using the keys
confirm with OK.
The machine searches for existing networks.
4 Select your existing network, or select NEW
NETWORK to create it, using the keys
confirm with OK.
If you choose an existing network,
Note steps 5 and 6 (and possibly 7) are
carried out automatically.
5 SSID appears on the screen, enter the name of
your network using the numerical keypad, pressing
the keys one after the other until you obtain the
name you want (32 characters maximum) and
confirm with OK.
6 AD-HOC MODE or INFRA. MODE appear on the
screen. Go back to the beginning of the chapter
and make your choice.
Select one of these modes and confirm with OK.
- If you choose AD-HOC mode, the sub-menu
CHANNEL appears, enter a figure between 1
and 13 (1 to 11 for the US) and confirm with OK.
7 Select your encryption method, OFF, WEP or
WPA, and confirm with OK:
Please note that in ad-hoc mode,
Important the WPA/WPA2 encryption method
is not available.
- If you choose WEP, enter the WEP key that you
are using on your network.
The WEP key number may be
configured in the menu:
Note
TECHNICALS / WEP KEYS NBR.
- 50 -
or and confirm
or and
or and
29 - SETUP /