Cables and Wiring Routing
Check that the cables, wiring leads and hoses
are routed correctly.
(Viewed from Front)
A. Throttle Cables
B. Wiring Band
C. Engine Stop Switch Lead
D. Launch Control Mode Button Lead
E. Clutch Cable
Position the front fender between the fork legs
and fasten it to the steering stem base with
four bolts (D = 6, L = 18.5).
Temporarily install the front bolts first, and
then the rear bolts.
Tighten all bolts securely.
A. Front Fender
B. Front Bolts (D = 6, L = 18.5)
C. Rear Bolts (D = 6, L = 18.5)
Front Number Plate
Handlebar Pad Installation
Install the handlebar pad onto the handlebar
bridge so that the characters on the pad are
shown as "RENTHAL" when viewed from the
front of the motorcycle.
A. Handlebar Pad
Front Number Plate Installation
Position the front number plate between the
brake hose and front fork, and fit the two holes
of the number plate to the projections of the
steering stem base.