Makita 2414NB Instruction Manual page 6

Securing cut-off
The cut-off may be bolted (2 bolts) down to
a level location using the bolt holes in the
base.
Removing
o r
installing cut-off wheel
CAUTION:
Always be sure that the tool is switched off and unplugged before removing or installing
the wheel.
To remove the wheel, raise the safety guide. Press the shaft lock so that the wheel cannot
revolve and use the socket wrench to loosen the hex bolt by turning it counterclockwise.
Then remove the hex bolt, outer flange and wheel. (Note: Do not remove the inner flange,
ring and O-ring.)
To install the wheel, follow the removal procedures in reverse.
CAUTION:
*Be sure to tighten the hex bolt securely. Insufficient tightening of the hex bolt may result
in severe injury. Use the socket wrench provided to help assure proper tightening.
*Always use only the proper inner and outer flanges which are provided with this tool.
*Always lower the safety guide after replacing the wheel.
Spark guard
The spark guard is factory-installed with its
lower edge contacting the base. Operating
the tool in this position will cause may
sparks to fly around. Loosen the screw and
adjust the spark guard to a position at
which minimum sparks will fly around.
6