Function Specifications; Operating Environment; Supported Oss; Table 2.2 Function Specifications (Eternus Dx60 S3) - Fujitsu ETERNUS DX60 S3 Overview Manual

Chapter 2 Specifications
2.2

Function Specifications

2.2 Function Specifications
This section contains the specifications of the functions for the ETERNUS DX.

Table 2.2 Function Specifications (ETERNUS DX60 S3)

Item
Supported RAID levels
RAID groups
Volumes
Number of connectable SAN hosts
(HBAs) (max.)
*1: Use of RAID0 is not recommended because it is not redundant. For RAID0 configurations, data may be
lost due to the failure of a drive.
*2: Fujitsu original RAID level that provides the high speed rebuild function, and striping with double dis-
tributed parity.
*3: The maximum number of RAID groups that can be registered (for the RAID1 configuration).
2.3

Operating Environment

This section explains the operating environment that is required for the ETERNUS DX operation.
2.3.1

Supported OSs

Servers and OSs that are supported by the ETERNUS DX as a SAN host are shown below.
For details on servers, Host Bus Adapters (HBAs), and driver software combined, refer to "Configuration Guide
-Server Connection-".
Number of RAID groups (max.) (*3)
Number of volumes per RAID group
Number of volumes (max.)
Volume capacity (max.)
Per storage system
Per port
17
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Overview
Copyright 2014 FUJITSU LIMITED
ETERNUS DX60 S3
0 (*1), 1, 1+0, 5, 5+0, 6, 6-FR (*2)
12
128
1,024
128TB
128
32
P3AM-8972-01ENZ0