Table of Contents
Advertisement
OPERATION MANUAL
2. INSTALLATION
2.1
Connect one end of handset coil cord to Handset and the other end to Base Unit.
2.2
Use the straight Line Cord to connect the Base Unit at socket (13) to Wall Outlet. Care must be
taken to ensure that the sockets match the respective plugs. In case your house is not equipped
with a compatible wall outlet, you may need an adaptor, or you should consult your
distributor/retailer for assistance.
The LCD display will change from low contrast to normal contrast during power charging. And then
user can operate the unit with the following steps.
2.3
Desktop
To install base support to the bottom of the base, insert the upper hooks to the base (1), and then
push base support forward to the base (2).
To remove base support from the bottom of the base, push the lower side of base support to
upward direction (3).
Wall Mount
This telephone set can be mounted on wall. To prevent the Handset from falling, take out the
Handset Guide (5), rotate it 180°, and then re-insert in the original place.
Rev: 4
P.3
Advertisement
Table of Contents
