KDL-32R330B/32R300B
8
US
Connecting the TV
Cable System or VHF/UHF Antenna System
You can enjoy high-definition and standard-
definition digital programming (if available in your
area) along with standard-definition analog
programming.
This TV is capable of receiving unscrambled digital
programming for both cable (QAM and 8VSB) and
external VHF/UHF antenna (ATSC).
Cable or VHF/UHF (or VHF only)
75-ohm
coaxial cable
Note
• It is strongly recommended that you connect the CABLE/
ANTENNA input using a 75-ohm coaxial cable to receive
optimum picture quality. A 300-ohm twin lead cable can
easily be affected by radio frequency interference,
resulting in signal degradation.
Cable System and VHF/UHF Antenna
System
Use an optional A-B RF switch (not supplied) to
switch between the cable and over-the-air antenna
programming, as indicated below.
Cable
Antenna
Note
• Be sure to set the Signal Type setting to Cable or
Antenna found under the Channel settings for your input
signal (page 20).
Rear of TV
CABLE/ANTENNA
A/B RF Switch
A
B
Rear of TV
CABLE/ANTENNA