Maytag AER5515QA Series Service Manual page 32

Electric freestanding range
Table of Contents

Advertisement

Installation Instructions
^kqfJqfm absf`b fkpq^ii^qflk fkpqor`qflkp
t^okfkdW A risk of range tip-over exists if the appliance
is not installed in accordance with the provided installation
instructions. The proper use of this device minimizes the
risk of TIP-OVER. In using this device the consumer must
still observe the safety precautions as stated in the USE
and CARE MANUAL and avoid using the oven door
and/or lower drawer as a step stool.
Installation instructions are provided for wood and cement
in either floor or wall. Any other type of construction may
require special installation techniques as deemed
necessary to provide adequate fastening of the ANTI-TIP
bracket to the floor or wall. The bracket may be installed
to engage the left or right rear leveling foot.
pqbm N J iŒ€~‘†‹„ q…‚ _~€ˆ‚‘
A. Determine where either the right or left "EDGE" of the
range will be located and mark the floor or wall.
B. Place the BRACKET 9/16² (14.5 mm) from the
marked "EDGE" toward center of opening and against
the back wall, as shown in figure 3, with orientation
hole against wall.
C. Use the bracket as a template and mark the required
holes, as shown in figure 3 for the type of construction
you will be using.
D. Free-standing range may be secured to either floor or
wall.
A – 4
pqbm O J ^‹‘†Jq† _~€ˆ‚‘ f‹‘~‰‰~‘†Œ‹
A. Wood Construction:
(See Figure 3)
B. Cement or Concrete Construction:
cfdrob P
16025644
l‘†Œ‹
1. Floor: Locate the center of the two holes identified
in figure 3 as "HOLES FOR FLOOR". Drill a 1/8²
(3 mm) pilot hole in the center of each hole (a nail
or awl may be used if a drill is not available).
Secure the ANTI-TIP bracket to the floor with the
two screws provided. Proceed to Step 3.
2. Wall: Locate the center of the two holes identified
in figure 3 as "HOLES FOR WALL". Drill an
angled 1/8² (3 mm) pilot hole in the center of each
hole as shown in figure 4. (A nail or awl may be
used if a drill is not available). Secure the
ANTI-TIP bracket to the wall with the two screws
provided as shown in figure 4. Proceed to STEP
3.
1. Suitable screws for concrete construction can be
obtained at the hardware store. Drill the required
size hole for the hardware obtained into the
concrete at the center of the holes identified in
figure 3 as "HOLES FOR FLOOR". Secure the
ANTI-TIP bracket to the floor. Proceed to STEP
3.
©2004 Maytag Services

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents