Test Mode - Maytag AEW3530DD Series Service Manual

Testing Procedures
To avoid risk of electrical shock, personal injury or death; disconnect power to oven before servicing, unless
testing requires it.

Test Mode

Follow procedure below to access the Test Mode.
1. Press SETUP pad.
2. Press DOWN ARROW pad three times until SERVICE is displayed.
3. Press SERVICE pad.
4. Press and hold BACK and ENTER pads for 5 seconds.
5. Press TEST pad.
NOTE: If the oven cavity temperature is greater then 400°F, the Test Mode cannot be activated or will abort the
mode if activated.
NOTE: Once the Test Mode is activated and a function is selected the control will activate the relay until the pad is
pressed again. Upon entering TEST Mode all relays are turned off except the DLB relays, which are turned
on. All relays are turned off when the TEST Mode is exited.
Pad Pressed
Beep
Version
Last Fault
DISP Test
UBAKE
UBROIL
UCONV
UCOOL
UCONV-H
UCONV-L
UMDL
ULITE
LBAKE
LBROIL
LCONV
LCOOL
LCONV-H
LCONV-L
LMDL
LLITE
22
!
W ARNING
Display last error code and oven configuration (single, double, convection, nonconvection)
Upper High Speed Convection Fan
Upper Low Speed Convection Fan
Lower High Speed Convection Fan
Lower Low Speed Convection Fan
16022506
Relay or Action Activated
1 Second Beep
Version of software
Display segments
Upper Bake Element
Upper Broil Element
Upper Convection Element
Upper Cooling Fan
Upper Motorized Door Lock
Upper Oven Light
Lower Bake Element
Lower Broil Element
Lower Convection Element
Lower Cooling Fan
Lower Motorized Door Lock
Lower Oven Light
©2003 Maytag Appliances Company