Download  Print this page


Media and tray
To avoid damaging the machine, use only labels designed for use in laser
When selecting labels, consider the following factors:
Adhesives: Should be stable at your machine's fusing temperature.
Check your machine's specifications to view the fusing temperature
(about 170°C (338°F)).
Arrangement: Only use labels with no exposed backing between them.
Labels can peel off sheets that have spaces between the labels, causing
serious jams.
Curl: Must lie flat with no more than 13 mm of curl in any direction.
Condition: Do not use labels with wrinkles, bubbles, or other
indications of separation.
Make sure that there is no exposed adhesive material between labels.
Exposed areas can cause labels to peel off during printing, which can cause
paper jams. Exposed adhesive can also cause damage to machine
Do not run a sheet of labels through the machine more than once. The
adhesive backing is designed for only a single pass through the machine.
Do not use labels that are separating from the backing sheet or are wrinkled,
bubbled, or otherwise damaged.
2. Menu overview and basic setup



Table of Contents

   Also See for Dell B1265dnf

   Related Manuals for Dell B1265dnf

Comments to this Manuals

Symbols: 0
Latest comments: