Download Print this page

KitchenAid Instant Hot Hot Water Dispenser Installation And User Manual page 7

Kitchenaid instant hot hot water dispenser installation instructions and use and care guide
Hide thumbs

Advertisement

Table of Contents
gasket
mounting
screw
square
nut
off
position
Installation Instructions cont.
NOTE: Do NOT plug power supply cord into outlet.
4.
Lay spout assembly on flat
surface with coiled tubing facing up.
Using one hand to hold tubing just
below spout, carefully straighten
5.
Loosen square nut until it is
flush with end of the mounting screw.
Tip spout bracket against mounting
screw. (Bracket will form a "y" when
in the correct position.)
bracket
6.
Pull up on spout body to keep
tension on spout mounting bracket
and nut. Tighten screw inside the
spout until spout is securely in
position. Do not overtighten. Snap
on On/Off Cap.
7.
Position tank vertically beneath
2-1/4"
(5.7 cm)
spout so that flexible tubing from
spout reaches center stainless tubing
on tank, and tank touches wall. Use a
pencil to mark on the wall where the
top of tank needs to be located. Set
tank aside. Mark a second line 2-1/4"
bracket
(5.7 cm) below the first line.
Note: The tank must be positioned
so that the flexible tubing to the
faucet does not kink.
tubing with other hand. Slide gasket
over tubing so that lip side of gasket
is seated into base of spout.
Hold nut, bracket, gasket and tubing
in position and insert into hole in sink
or counter.
Position mounting bracket on wall so
that bottom of mounting bracket is
even with the lower line. Use two
screws (and plastic anchors if
attaching to dry wall) to fasten
mounting bracket to wall. Hang tank
on bracket.
7

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for KitchenAid Instant Hot Hot Water Dispenser