Pioneer BDP-320 Service Manual page 32

1
QQ
3 7 63 1515 0
A
[4] OSD FILTER SETTING
While a monitor from a manufacturer other than Pioneer is connected, symptoms such as greeking and improper video
display may be generated. In such a case, set the OSD FILTER to ON in OSD FILTER SETTING mode then check the video
display. The initial setting of OSD FILTER is OFF. Normally, set it to OFF.
To enter this mode, press the [ESC] then [DISP] keys to display the service screen.
Then press the [DIG/ANA] key once to switch to the OSD Filter Setting screen.
Input of the above keys are accepted both in Normal Startup mode and Checker mode.
• OSD FILTER SETTING screen
B
1
1 OSD FILTER SETTING value
C
[initial setting :
Key operations of the OSD FILTER SETTING screen
TE
L 13942296513
Key
For switching the OSD FILTER SETTING
[<x3], [x3>]
between ON or OFF
[ESC] For clearing data or exiting the current mode
D
* Use the remote control unit for service for key operation.
* A setting becomes valid as soon as it is set. The setting value will be stored in nonvolatile memory, as with the setting
values of the main unit. Therefore, the changed setting value will be retained upon the next power-on.
* About factory preset
• If the ESC then CLEAR keys are pressed ("No power off" command) for factory presetting, the setting will be reset to
default (ON).
• If the STOP and POWER keys on the main unit are pressed simultaneously for factory presetting, the current setting
will be retained.
E
www
F
32
1
http://www.xiaoyu163.com
2
ON
OFF
OFF]
Operation
x ao
y
. i
2
http://www.xiaoyu163.com
3
8
Q Q
3 6 7 1 3
Setting value
(*: Default)
[<x3]: To set the OSD Brightness Filter to OFF
OFF/ON ( * )
[x3>]: To set the OSD Brightness Filter to ON
− −
u163
.
BDP-320
3
4
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
Remarks
m
co
4
9 9
2 8 9 9