Disassembly And Service; Safety Precautions; Control Panel; Electronic Control - Frigidaire Fully Integrated Direct FeedModel Dishwashers Service Manual

Fully integrated direct feed model dishwashers

Hide thumbs

Table Of Contents

Table of Contents

SAFETY PRECAUTIONS

Always turn off electrical power supply before

servicing any electrical component, making ohmme-

ter checks, or making a part replacement. Refer to

safe service procedures at the front of this service

manual before servicing the dishwasher.

All voltage checks should be made with a voltmeter

having a full scale of 130volts or higher.

After service is completed, be sure all safety ground-

ing circuits are complete, all electrical connections

are secure, and all access panels are in place.

CONTROL PANEL

Note:

Console will come as console assembly consisting

of the following; console, keypad (installed), and

foam blocks around ribbon.

1. Disconnect the dishwasher from electrical supply.

2. Remove the outer door panel;

a. The outer door panel is held to the inner

door panel by two screws and four

locking tabs, two on each side of the

door panel.

b. Remove the lower two screws, one on

each side that secures the outer door to

the inner panel.

c. Close the door and slide the door panel

down and outward to remove.

6. Remove the six remaining screws mounting the

control panel to the inner door.

Electronic Control

1. Disconnect the dishwasher from electrical supply.

2. Remove outer door panel

3. Remove console from top of inner door panel

4. Remove control cover (3) mounting screws.

5. Remove wires and plugs connectors See Figure 30

6. Raise ribbon lock and remove ribbon from control

See Figure 30

7. Remove control

On installation make sure all wires are

connected in proper location and tight to

terminal.