Assembly; Laser Beam; Mitre Angle Adjustment; Superlok Mitre Clamp - Black & Decker SMS254 Manual

ENGLISH
6. Table extension material stop (right)
7. Table extension (right)
8. Kerf plate
9. Superlok™ mitre clamp
10. Mitre lock knob
11. Mitre detent lever
12. Mitre position adjustment pointer
13. Mitre scale
14. Rotating table
15. Bench mounting holes
16. Clamp locating mounts
17. Table extension (left)
18. Table extension material stop (left)
19. Table extension securing knob
20. High sliding fence clamp
21. Left-hand fence
22. Left-hand high sliding fence
23. 33.9° bevel pin
24. Rear carry handle
25. Saw dust outlet
26. Metal upper guard
27. Front carry handle
28. Removable brush box
29. Carriage
30. Bevel lock handle
12
31. Bevel scale
32. Right-hand fence
33. Laser
34. Saw blade
35. Spindle lock button
36. Saw arm release lever
Fig. R
53. Clamp

Assembly

Warning! Before assembly, make sure that the
tool is switched off and unplugged.
Note: This tool is accurately adjusted before
shipping from the factory. Check the following
accuracy and readjust them if necessary in order
to obtain the best results in operation.

Laser beam

The laser beam alignment is set at the
manufacturing source and is not user adjustable.

Mitre angle adjustment

The sliding compound mitre saw scale can be
easily read showing mitre angles from 0° to 47°
to the left and the right. The most common angle
cut setting slots have positive stops, permitting
fast adjustments to the required position. Follow
the process below for quickest and most
accurate adjustments.
Superlok™ mitre clamp (fig. B)
The Superlok™ mitre clamp (9) allows the saw to
be set to specific angles other than the preset
angles of 0°, 15°, 22.5°, 31.6°, and 47° which
are set using the mitre detent lever (11).