Getting Started; What's In The Box; Getting It Out Of The Box; Powering Up - Blizzard Lighting Puck Q6 Unplugged User Manual

1. GETTING STARTED

What's In The Box?

• 1 x Puck Q6 Unplugged™ Flat LED PAR Fixture
• 1x Mounting Bracket & 2 Knobs
• 1x IEC Power Cord
• This Eloquently Written User Manual

Getting It Out Of The Box

Congratulations on purchasing the sweetest battery powered LED PAR can on
the market! Based on our world famous Puck3™ and taking into account all
the enhancements of Puck 3NX™, THEN adding our proprietary ultra long-life
intelion™ Lithium-Ion Battery System give you a fixture with TONS of output,
flexibility and fantastic battery-powered run time.
Now that you've got The Puck Q6 Unplugged™ (or hopefully, Pucks!), you
should carefully unpack the box and check the contents to ensure that all parts
are present and in good condition. If anything looks as if it has been damaged
in transit, notify the shipper immediately and keep the packing material for
inspection. Again, please save the carton and all packing materials. If a fixture
must be returned to the factory, it is important that the fixture be returned in
the original factory box and packing.

Powering Up!

All fixtures must be powered directly off a switched circuit and cannot be run
off a rheostat (variable resistor) or dimmer circuit, even if the rheostat
or dimmer channel is used solely for a 0% to 100% switch.
AC Voltage Switch - Not all fixtures have a voltage select switch, so please
verify that the fixture you receive is suitable for your local power supply. See
the label on the fixture or refer to the fixture's specifications chart for more
information. A fixture's listed current rating is its average current draw under
normal conditions. Check the fixture or device carefully to make sure that if a
voltage selection switch exists that it is set to the correct line voltage you will
use.
Warning! Verify that the voltage select switch on your unit matches
the line voltage applied. Damage to your fixture may result if the line
voltage applied does not match the voltage indicated on the voltage se-
lector switch. All fixtures must be connected to circuits with a suitable
Ground (Earthing).

Getting A Hold Of Us

If something is wrong, just give us a call or send an email. We'll be
happy to help, honest.
Blizzard Lighting
W220 N1531 Jericho Ct. Suite E, Waukesha, WI 53186 USA
support@blizzardlighting.com
www.blizzardlighting.com
414-395-8365
The Puck Q6: Unplugged Manual Rev. A
Page 4
Copyright (c) 2012 Blizzard Lighting, LLC