Installing The Input/Output (I/O) Panel; Removing The Power Supply - Dell OptiPlex 9010 Owner's Manual

4. Remove the screw that secures the I/O panel to the chassis. Then, slide the I/O panel to the right to release and
remove from the computer.

Installing the Input/Output (I/O) Panel

1. Insert the I/O panel into the slot on the chassis front.
2. Slide the I/O panel towards the left of the computer to secure to the chassis.
3. Tighten the screw to secure the I/O panel to the chassis.
4. Connect the I/O panel/FlyWire cable to the system board.
5. Thread the I/O panel/ FlyWire cable into the fan-shelter clip and the routing on the heat sink.
6. Install the:
a. drive cage
b. front bezel
c. cover
7. Follow the procedures in

Removing the Power Supply

1. Follow the procedures in
2. Remove the:
a. cover
24
After Working Inside Your Computer .
Before Working Inside Your Computer .