Advertisement
1.Connect the water inlet hose. Open the water faucet.
2.Confirm that the washing machine is earthed reliably.
Then insert the power plug into the receptacle. The
earth terminal shall not link to gas pipeline and faucet
water pipeline.
3.Put down the drain hose.
Check if the laund
Clear the pocket.
Tie the long strips;
ries has special
Take out the coins,
fasten the buttons;
requrement on
sand, hairpins etc.
close zippers.
washing
a.Check if the laundries are applicable for washing with machine.
b.Divide the laundries that are not colorfast from other laundries.
c.Put those laundries diffi cult to absorb water into water with hand.
d.For those laundries with heavy soil, please fi rst remove the dirt like mud or dust.
e.For the partswith heavy soil, please apply detergent on them in advance, which can make it easier to
remove the soil.
f.For those laundries that may get lint ball and those with long fur, turn it over before putting in.
g.Do not put those laundries polluted by chemicals into the washing machine directly.
The quantity of the
When the pulsator is
laundries shall not
running, the buttons of
be too large. Stretch
the laundries may cause
and loosen the
noise.
laundries before
For the sake of discretion,
putting them in the
please put the laundries
tub.
with buttons into other
laundries.
9
For HWM60-12699NZP:
1.Dismantle the back cover of the washing machine.
2.Press the spring lamination lightly and pull the top
segment of the drain hose decumbent then put
down the drain hose from the drain hose frame.
3.Put down the drain hose, squeeze the drain hose
lightly and take off the hook, put the drain hose into
the cabinet. Take off the small baffle which installed
on the other drain outlet and install it on the side
which won't install the drain hose.
4.Extend the drain hose from the other side and install
it on the base by the drain hose frame
5.Install the back cover.
Remark: In order to make sure of the correct of installation, it is suggested to change the
direction of the drain hose with our company serviceman.
1.The height of the drain hose shall be less .
than 10cm , or the drainage will not be smooth,
and cost such long time that the machine may
stop at mid way.
2. Do not trample or press the drain hose
3.If the drain hose is too long, cut it at mid
point. To make smooth drainage,cut the front
end of the hose slantingly.
Back cover
Drain hose frame
Spring lamination
4.If extra drain hose is needed,please
make separate purchase.The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
5.If the extra hose is too long,cut it either at
A or at B point.
6
Advertisement
