Table of Contents
Advertisement
Device Verify screen
Use the Device Verify screen to verify a particular device. To access this screen, press Enter in the
appropriate field on the Device Properties screen.
Press Enter to begin the verify process. Press Esc to cancel the verify process at any time.
If the logical block addresses (LBAs) can be reassigned or must be reassigned, the following prompt
appears after pressing Enter:
Reassign the block?
(Yes, No, All, nonE, Cancel)
The reassignment options are as follows:
•
Yes—Reassign only this block. If another block must be reassigned in the future, display the prompt
again.
•
No—Do not reassign this block. If another block must be reassigned in the future, display the prompt
again.
•
All—Reassign the current block, and automatically reassign other blocks that must be reassigned,
without displaying the prompt again.
•
nonE—Do not reassign the current block, and do not automatically reassign any other blocks that
must be reassigned. Do not display the prompt again.
•
Cancel—Do not reassign any blocks and stop the verify process.
Exit Menu screen
The SAS BIOS configuration utility must be exited properly because some changes take effect only during
the exit process.
SAS BIOS configuration utility 16
Advertisement
Table of Contents
