Charging The Battery - Siemens C62 User Manual

Charging the battery

The battery is not supplied fully
charged. Plug the charger cable into
the bottom of the phone, plug the
power supply unit into the mains
power socket and charge for at least
3,5 hours.
Display when charging is in progress
During charging.
Charging time
An empty battery is fully charged af-
ter about 3,5 hours. Charging is only
possible within the temperature
range of +0 °C to +45 °C. If the tem-
perature rises/falls above/below this,
the charge symbol flashes a warn-
ing. The voltage specified on the
power supply unit must not be ex-
ceeded.
To obtain maximum performance of
the battery it must be fully charged
and then emptied at least five times.
Getting started
Charge icon not visible
If the battery was completely dis-
charged, the charging symbol will
not be immediately visible when
connected to the charger. In this
case the battery is fully charged after
4,5-5,5 hours.
Only use the charger provided!
Display while in service
Charge level display during opera-
tion (empty-full):
A beep sounds when the battery is
nearly empty. The charge level of the
battery is displayed correctly only af-
ter uninterrupted charging/discharg-
ing. You should therefore not remove
the battery unnecessarily and where
possible not interrupt charging prema-
turely.
Note
The charger will become hot after extended
use. This is normal and not dangerous.
Performance................................ page 78
Battery quality statement............. page 76
9