Operating Times And Preparations; Switching On And Off; Cleaning And Maintenance - Black & Decker MZ3000PG User Manual

English
Combination 2 (36% Microwave and 64%
Grill)
• Press the "Grill/Combi"
three times: The LED display will show
" " and "
Enter the required cooking time using the
numeric keypad.
• Press " START/EXPRESS COOK "
button to start cooking. The cooking
time counts down, " : " and "
flash.
• The maximum cooking time is 100
minutes and 39 seconds.
Note: During Combination Cooking, the
"Grill / Combi" GRILL/
COMBI.
pressed to display the Grilling mode in the
LED for 3 seconds. After three seconds,
the display will revert to normal.

Operating times and preparations

Follow directions on food packaging.

Switching on and off

The microwave will start to cook once the
Start / Express Cook
pressed.
To stop the oven during operation, press
the Stop / Clear
STOP
CLEAR

Cleaning and maintenance

The oven should be cleaned regularly and
any food deposits removed
GRILL/
button
COMBI.
" icon.
START
EXPRESS COOK
" will
button can be
START
button is
EXPRESS COOK
button .
Failure to maintain the oven in a clean
condition could lead to deterioration of the
surface that could adversely affect the life
of the appliance and possibly result in a
hazardous situation
Turn the oven off and disconnect from the
power supply before cleaning.
The outside oven surface & control panel
should be cleaned with a damp cloth.
When cleaning surfaces of door, door seal,
cavity of the oven, use only mild,
non-abrasive soaps, or detergents applied
with a sponge or soft cloth.
The glass tray can be washed in warm
sudsy water or in a dishwasher & dried with
a clean cloth.
The roller support and oven cavity should
be cleaned regularly. The cavity should be
cleaned with a damp cloth & a mild
detergent & dried thoroughly. The roller ring
should be washed in warm sudsy water or
in a dish washer.
Note: To prevent damage to the operating
parts inside the oven, water should not be
allowed to enter the ventilation slots.
Do not use detergents, abrasives or
spray-on cleaners on the control Panel.
Do not allow the Control Panel to become
wet.
-11-