Hotpoint Ariston LFF 825 IT Service Manual

Hotpoint Ariston LFF 825 IT Service Manual

Eos dishwasher platform. free standing digit interface (level iii)

Advertisement

Service
Manual
GB
Service Manual
Manual LFF 825 IT/HA
1 ISSUE - APRIL 2008
EOS DISHWASHER
PLATFORM.
FREE STANDING
DIGIT INTERFACE
(LEVEL III)
MODELS
Covered
LFF 825 IT/HA
Edition
2008.04.01
COMM
Code
50262
Language
English

Advertisement

Table of Contents
loading

Summary of Contents for Hotpoint Ariston LFF 825 IT

  • Page 1 1 ISSUE - APRIL 2008 EOS DISHWASHER PLATFORM. FREE STANDING DIGIT INTERFACE (LEVEL III) MODELS COMM Covered Code LFF 825 IT/HA 50262 Service Manual Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 2: Table Of Contents

    Industrial code: 37 46454 0200 Commercial and Technological modifications Commercial code Factory Code Serial Number: 7 06 14 1476 Factory Correlative Day of Manufacture Month of Manufacture Year of Manufacture Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 3: Chapter 1 Product Description

    D: Dishwasher D: LCD 5: Aquarius Number Series: 0-9 P: Polar S: Slimline F: Digit 7: Acquarius + Programmes G: Graphite L: LED 9: Ultima A: Aluminium M: Mechanical K: Black Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 4: Control Panel

    Extra drying button and indicator light * 14 Low rinse aid indicator lights * Residual time indicator light 15 On-Off/Reset button Half load button and indicator light * * Only present on some models Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 5: General Technical Data

    Failure to take this precautionary measure may result in a blockage and consequently damage to the dishwasher. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 6: Drain Connection

    600 mm min. Fit hose to waste min. securely using a ‘Jubliee type clip FIGURE: Tap height 600 mm min. Fix the drain hose securely using a hose clamp with screws. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 7 Connect the GREY drain hose to the support bend, as shown. If installing the drain system below the sink, cut the membrane, plug or cover. Fit the drain hose securely to the waste below the sink. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 8: Chapter 4 Product Description

    “Washing times” are adjusted automatically based on the wash options selected by the use and the degree of soiling of crockery being washed. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 9: Wash Options

    The programme is interrupted if the door is opened or if there is a power cut. When the door is shut or the power supply restored, the dishwasher will resume the wash cycle from where it was interrupted. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 10: Innovative Features

    6 regeneration cycles, after which it will switch on the salt indicator. If the salt indicator is on, the dishwasher will not perform the regeneration cycle, even if the number of litres loaded exceeds the limits set by Editor. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 11 (so for example, not with the soak programme). If the number of litres of water loaded exceeds the Editor setting for the particular hardness selected (see attached Table) at the end of the cycle the appliance will run the resin regeneration cycle. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 12 In the event of chronically clogged filters, the user may call to report crockery still being dirty at the end of a wash cycle. Advice for the Call Center: wash the filters Position pots upside down and try washing again Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 13: Chapter 5 Components

    3. Permit the entry of around 3% of unsoftened water to prevent the formation of excess suds 4. House the Litre-Counter Turbine Unlike the previous model, this Air break does not hold water. Bear in mind that the resin regeneration process in this platform differs. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 14: Pressure Switch

    They are located between the wash compartment (rack) and the plastic support. Note.: The hinges of built-in and free-standing appliances are not interchangeable. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 15: Drain Pump

    (2) Thermoprotector: 95° C +/- 5° C - Thermofuse: 206° C +/- 10° C (3) Thermoprotector: 95° C +/- 5° C - Thermofuse: 206° C +/- 10° C (4) Thermoprotector: 95° C +/- 5° C - Thermofuse: 206° C +/- 10° C Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 16: Chapter 6 Electrical Diagram

    The new electronic EOS platform does not have the integrated long autotest function that we are familiar with (“ROD”); it can only start and test dishwashers with the short “SAT” cycle. A description of how this is done is provided. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 17: Sat" Autotest Start Sequence

    Autotest is run. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 18: Fault Display

    7.2.3. FAULT DISPLAY 7.2.4. FAULTS TABLE ALARM TABLE PLATFORM “EOS” (DEA 601) Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 19: Dr. (Pc, Palm, Smart Reader)

    Very Important: When working on the Main PCB, close the front door: it is very important to make sure that the wires of the PCB do not create mechanical interference with the float. This could block it. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 20: Chapter 8 Disassembly

    1. Remove the four screws (two front, two rear) which secure the right side panel and remove the panel. 2. Remove the filter, sliding it out along its support runners. 3. Disconnect the RFI filter. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 21 3. Remove the two fixing screws of the top rotor delivery hose to release it from its coupling. 4. Use a flat blade screwdriver for leverage at the side in order to release the upper rotor delivery hose from its seat. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 22 1. Open the door. 2. Remove the 2 screw (one each side) which fix the plinth to the dishwasher base. 3. Pull it gently at the bottom to release. 4. Remove completely. Service Manual Edition Language Manual LFF 825 IT/HA 2008.04.01 English...
  • Page 23 Language Edition Service Manual English 2008.04.01 Manual LKF 72-71 LBF 51-5...

This manual is also suitable for:

Lff 825 haLft 228Lkf72 a enFdl570pLff 825 it/ha

Table of Contents