System Initialization; Entering The Security Code - Acura 2008 TL Navigation System User Manual

Main Menu

System Initialization

System Initialization
If for any reason, you lose power to the
navigation system (like the battery was
disconnected), the navigation system
will require initialization. Once
completed, your system will be ready to
use.
This initialization requires the
following:
• Entry of the 4-digit anti-theft security
code to "unlock" the navigation
system.
• GPS initialization (may not be needed
depending on the length of time the
system was without power).
• Map matching to align the GPS
coordinates to a place on the map
(displays current street at the bottom
of the map).
102 Navigation System

Entering the Security Code

If the battery goes dead or is
disconnected for any reason, you will
have to enter a security code for the
navigation system before you can use it
again.
When you purchased the vehicle, you
should have received two cards that
have the audio and navigation system's
security codes and serial numbers. Keep
these cards in a safe place in case you
need the codes. If you lose the cards,
you must obtain the security codes from
your dealer.
2008 TL
Enter the four-digit security code, then
select Done. If you have entered it
correctly, the display changes to the
Disclaimer screen. If you make a
mistake, the system will display
"incorrect PIN." Re-enter your 4-digit
security code. You have ten chances to
enter the correct code. If all ten are
incorrect, turn the ignition to OFF, then
back to ON (II) to have ten more
chances to enter the correct code.
Follow the instructions in the vehicle
Owner's manual to enter the 5-digit
audio code. The navigation voice will
not operate if the audio code is not
entered.
NOTE:
The anti-theft security code is unrelated
to your optional Navigation system PIN
(for Personal or Home Address).