Table of Contents
Advertisement
16
•
The MW810 Manager application allows selecting the state of the Bluetooth module
after operating system start. Factory registry setting is ON.
Smart Card Reader
The MW810 12.1" Displays incorporate a Smart Card Reader based on the OMNIKEY®
Smart@Link Chipset 83C230K203 with an internal USB 2.0 Host Interface (also compliant
with USB 1.1) with a transmission speed of 12 Mbps (USB 2.0 full speed).
Key Features:
•
Complies with ISO 7816
•
EMV² 2000 Level 1
•
GSA Fips201 approved product list
•
PC/SC driver
•
Protocols T=0, T=1 (2-wire: SLE 4432/42 (S=10), 3-wire: SLE 4418/28 (S=9))
•
Card size ID-1 (full-size)
•
Card types 5V, 3V and 1.8V Smart Cards
•
Smart Card interface speed 119 Kbps (when supported by card)
•
Smart Card clock frequency Up to 8 MHz
•
Smart Card detection
•
Card vendor supplied Application Program Interface
•
Windows XP
•
Windows Vista (32bit / 64bit)
Installation
Generally, the drivers and the configuration utility are already preinstalled. If the drivers and
the tools have not yet been installed, you can find the install package in the
D:\Setup\SmartCard folder of the original MW810 operating system image or reinstall the
SCR software by using the MW810 Field Support Kit CD-ROM.
If it should be necessary to reinstall the SCR software, proceed as follows:
•
Close all open programs.
•
Connect USB CD-ROM drive to the CPU
•
Insert the Field Support Kit CD into the CD-ROM drive
•
When the main menu appears, push the
instructions on the screen
NOTE: You may require administrator rights to install software. Make sure you have the
necessary rights.
User applications can communicate with the SCR device via
Application Programming Interface.
6802982C85-C
button and follow the
SPECIAL DRIVERS
card vendor supplied
Advertisement
Table of Contents
