Refrigerator Care; Cleaning - KitchenAid SIDE BY SIDE BUILT-IN REFRIGERATOR Use And Care Manual

Door Bins
To remove and replace the door bins:
1. Remove the bin by lifting it up and pulling it out.
2. Replace the bin by insert the hooks into the slots on both
sides of the refrigerator door. Push the bin down to lock it into
place.

REFRIGERATOR CARE

Cleaning

Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion,
or fire.
Both the refrigerator and freezer sections defrost automatically.
However, clean both sections about once a month to prevent
odors from building up. Wipe up spills immediately.
To clean your refrigerator:
1. Remove the top grille. See the "Power On/Off Switch"
section.
2. Press power switch to the OFF position.
3. Remove all removable parts from inside, such as shelves,
crispers, etc.
4. Hand wash, rinse, and dry removable parts and interior
surfaces thoroughly. Use a clean sponge or soft cloth and a
mild detergent in warm water.
Do not use abrasive or harsh cleaners such as window
sprays, scouring cleansers, flammable fluids, cleaning
waxes, concentrated detergents, bleaches or cleansers
containing petroleum products on plastic parts, interior
and door liners or gaskets. Do not use paper towels,
scouring pads, or other harsh cleaning tools. These can
scratch or damage materials.
To help remove odors, you can wash interior walls with a
mixture of warm water and baking soda (2 tbs. to 1 qt.
[26 g to .95 L] of water).
14
5. Wash stainless steel and painted metal exteriors with a clean
sponge or soft cloth and a mild detergent in warm water. Do
not use abrasive or harsh cleaners. Dry thoroughly with a soft
cloth. For additional protection against damage to painted
metal exteriors, apply appliance wax (or auto paste wax) with
a clean, soft cloth. Do not wax plastic parts.
NOTE: To keep your Stainless Steel refrigerator looking like
new and to remove minor scuffs or marks, it is suggested that
you use the manufacturer's approved Stainless Steel Cleaner
& Polish.
IMPORTANT: This cleaner is for Stainless Steel parts only!
Do not allow the Stainless Steel Cleaner & Polish to come into
contact with any plastic parts such as the trim pieces,
dispenser covers or door gaskets. If accidental contact does
occur, clean plastic part with a sponge and mild detergent in
warm water. Dry thoroughly with a soft cloth. To order the
cleaner, see the "Accessories" section.
6. Clean the condenser coils located behind the top grille
ventilation panel regularly. Coils may need to be cleaned as
often as every other month. This may help save energy.
Use a vacuum with an extended attachment to clean the
condenser coils when they are dusty or dirty.
7. Clean defrost pan using mild detergent in warm water. Dry
thoroughly.
Remove the base grille by removing a screw at each end.
Remove the defrost pan by pushing up on the retaining
clip under the refrigerator while sliding the pan forward.
1
1. Defrost pan
2. Retaining clip
Replace the defrost pan by positioning the edge of the
defrost pan approximately 7 in. (17.8 cm) from the left
side of the refrigerator. Lift defrost pan into guides and
push back and place pan inside of retaining clip. Replace
the base grille and base grille screws.
8. Press the power switch to the ON position.
9. Replace the top grille. See the "Power On/Off Switch"
section.
2