Making Tp Port Connection; Making Fx Port Connection - Xerox NC-300D Series Installation Manual

2.4 Making TP Port Connection

TP port is featured to support connection to :
•
Auto-negotiation devices
•
Auto-negotiation incapable 10BASE-T devices
•
Auto-negotiation incapable 100BASE-TX devices
Network Cables
10BASE-T:
100BASE-TX:
Link distance:
Configuration Setup
To make a proper connection, the following configuration settings are
recommended:
TP port link partner
Auto-negotiation device
Fixed 10M half duplex device On: forced
Fixed 100M half duplex device On: forced
Fixed 10M full duplex device On: forced
Fixed 100M full duplex device On: forced

2.5 Making FX Port Connection

FX port operates on 100Mbps and full duplex (factory default). A variety
of fiber options is listed in Section 1.3
2-pair UTP Cat. 3,4,5 , EIA/TIA- 568 100-ohm STP
2-pair UTP Cat. 5, EIA/TIA-568 100-ohm STP
Up to 100 meters
SW1
Off: auto
SW2
Off: full duplex
On: half duplex
On: half duplex
Off: full duplex
Off: full duplex
-14-
SW3
Off: 100M
On: 10M
Off: 100M
On: 10M
Off: 100M