Port Forwarding - D-Link DIR-880L User Manual

Section 4 - Configuration
Port forwarding allows you to specify a port or range of ports to open for specific
devices on the network. This might be necessary for certain applications to connect
through the router. In the Features menu on the bar on the top of the page, click

Port Forwarding.

If you wish to remove a rule, click on its trash can icon in the Delete column. If you
wish to edit a rule, click on its pencil icon in the Edit column. If you wish to create a
new rule, click the Add Rules button
create a rule, the following options will appear:
Name: Enter a name for the rule.
Local IP:
Enter the IP address of the computer on your local network that you
want to allow the incoming service to. Alternatively, select the device
from the drop-down menu.
TCP Port:
Enter the TCP ports that you want to open. You can enter a single
port or a range of ports. Separate ports with a comma (for example:
24,1009,3000-4000).
UDP Port:
Enter the UDP ports that you want to open. You can enter a single
port or a range of ports. Separate ports with a comma (for example:
24,1009,3000-4000).
Schedule:
Use the drop-down menu to select the time schedule that the rule
will be enabled on. The schedule may be set to Always Enable, or
you can create your own schedules in the Schedules section (refer
to page 116).
Click OK when you are done.
D-Link DIR-880L User Manual
Port Forwarding
.
Click Save when you are done. If you edit or
107