Caring For Your Cooktop; Surface Burners - KitchenAid YKGRT507 Use And Care Manual

Thermal-convection gas freestanding and slide-in ranges
Hide thumbs Also See for YKGRT507:
Table of Contents

Advertisement

Caring for your cooktop

Your cooktop is designed for ease of care.
You can do most cleaning with items found
around the home. Cleaning your cooktop
whenever spills or soiling occur will help to
keep it looking and operating like new.
NOTES:
Before cleaning make sure all controls
are off and the cooktop is cool.
Do not obstruct the flow of combustion
and ventilation air.
If knobs are removed while cleaning, be
careful not to spill liquids through holes in
the control area.
Be careful not to allow moisture to collect
in control area. Moisture could cause
ignitor switches to fail.

Surface burners

The burner caps should be routinely
removed and cleaned. Always clean
burner caps after a spillover. Keeping the
burner caps clean prevents improper
ignition and an uneven flame.
For proper flow of gas and ignition of the
burner, DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS, OR ANY OTHER
MATERIAL TO ENTER THE GAS TUBE
OPENING.
Occasionally check the burner flames for
proper size and shape as shown later in
this section. A good flame is blue in color.
If flames lift off ports, are yellow, or are
noisy when turned off, you may need to
clean the burners.
NOTE:
To check oven burner flames for
proper size and shape, see the Installation
Instructions also included with the range.
U
C
sing and
To clean burners and burner caps:
1.
2.
3.
4.
5.
6.
Y
aring for
our
Burner cap
Lift the burner cap straight up from the
burner base.
Clean burner cap with warm, soapy water
and a sponge. For stubborn stains, clean
with a mildly abrasive plastic scrubbing
pad and powdered cleanser. Do not clean
burner cap in dishwasher.
If the gas tube opening or the orifice,
located inside the opening, has become
soiled or clogged, use a cotton swab or
a soft cloth to clean the area.
If ports are clogged, clean with a
straight pin. Do not enlarge or distort
port. Do not leave anything stuck in
the ports.
After cleaning the gas tube opening and
ports, replace the burner cap. To replace
burner cap, make sure cap is properly
aligned and leveled.
Check the burner after cleaning for
proper lighting.
C
ooktop
Ignitor
Gas tube
opening
(orifice)
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ykgst307Kgrt507Kgst307

Table of Contents