16.1.2 Overview of Service Support Tool (Touch panel type)
When using the SST, select "#DOWNLOAD" in the service mode to place the main unit in the download mode. (The finisher need not enter the download mode.)
16.2 Making Preparations
16.2.1 Registering the System Software (Touch panel type)
System software programs to be downloaded need to be registered in the SST.
The system software programs are registered with the names listed below.
<Software Programs Preinstalled in Main Unit>
Machine name: iR2018i/iR2022i/iR2022K/iR2025/iR2025i/iR2030/iR2030i
- Main controller: System
- Boot program: Boot
- 16MB ROM PCB: PCL_op (for the standard model)
- 32MB ROM PCB: PCL_Common (for the model equipped with the PCL printer kit-W1)
- CA certificate (distributed only as necessary)
Have the following ready:
- PC in which SSTv3.21 or later is installed (Download a CA certificate of version of SSTv3.31 or higher)
- System CD
[System Software Registration Procedure]
1) Start the PC.
2) Insert the system CD in the PC.
3) Start SST.
Image processor PCB
16MB ROM PCB
PCL printer kit-W1
32MB ROM PCB
Finisher controller PCB