Step 4: TV monitor and Video Component Hookups
Note
Refer to the instructions supplied with the components to be connected.
Required cords
Video cord for connecting a TV monitor
Yellow
Audio/video cords (not supplied)
When connecting a cord, be sure to match the colour-corded pins to the appropriate jacks on the
components.
Yellow (Video)
White (L/audio)
Red (R/audio)
Jacks for connecting video component
Connect a
TV monitor
VCR
Digital satellite receiver
z
When using the S-video jack instead of the video jacks
Your TV monitor must also be connected via an S-video jack. S-video signals are on a separate bus from the video signals
and will not be output through the video jacks.
Notes
• When you select VIDEO 1 using the FUNCTION button, the signal is output from the front L/R
speakers, but not from the VIDEO 1 VIDEO OUT and AUDIO OUT L/R jacks.
• When you use the Video 1 line outputs, please set the unit to 2CH STEREO mode. If the unit is not in
2CH STEREO mode, the line outputs may not function properly.
GB
22
To the
MONITOR OUT jack
VIDEO 1 jacks
VIDEO 2 jacks
Yellow
Yellow (Video)
White (L/audio)
Red (R/audio)