Rinse Aid; Ensuring Hot Water - Maytag Dishwasher User Manual

CHECKING RINSE AID ENSURING HOT WATER
reduces spotting and filming, water is necessary. The incoming water tem-
perature should be 120-140°F to properly
Your Maytag Jetelean
TM
dishwasher features an auto- activate the detergent and melt greasy food
matie rinse aid dispenser located near the detergent soils.
cups in the door.
If for any reason (such as laundering, showers, etc.) the
The clear window in the center of the dispenser cap incoming water temperature is below 120°F (49°C),
allows you to see if there is rinse aid in the reservoin select the Temp Sense option to have the dishwasher
When the window is colored, there is rinse aid in the thermostatically heat the water to proper temperature.
dispenser. When the _dndow becomes clear, it is time
to refill the dispenser. (As a guide, check the dispenser To check the incoming water temperature, turn on the
monthly.) hot water faucet nearest the dishwasher and let it run
into a glass in the sink. Place a candy" thermometer in
the glass and check the temperature once it has stopped
rising. If the temperature is below 120°F (49°C), have a
qualified person raise the water heater thermostat set-
ting.
": _ _ ; i Before starting the dishwasher, turn on the hot water
/ _/ f_ueet and let it run until the water is hot.
_s d_ ; /
To add rinse aid to the dispenser, turn the cap counter-
elocGvise to open. Remove the cap and pour liquid
rinse aid into the opening. Replace the cap and turn it
clockwise.
An adjustable cap found on some models allows you to
adjust the amount of rinse aid dispensed. A raised dot
on the cap indicates the recommended initial setting.
Typically, use the LESS setting for soft water and the
MORE setting for hard water. Set the cap anywhere
between these amounts as needed. To improve drying,
turn the cap towards the MORE setting. When adjust-
mg or replacing the cap, be sure it is securely in place
before closing the dishwasher door.
Page 6