System - D-Link DIR-505 User Manual

Section 5 - Repeater Mode
This page allows you to save and restore your configuration, reset and reboot the DIR-505, and remove any added language
packs.
Save Settings Clicking the Save button will allow you to save the current
To Local Hard repeater configuration settings to a file on the hard disk of
Drive: the computer you are using. You will then see a file dialog
where you can select a location and file name for the settings.
Load Settings Use this option to load previously saved configuration
From Local settings. Click Browse to find a previously saved configuration
file. Then, click the Upload.Settings button to transfer those
Hard Drive:
settings to the DIR-505.
Restore This option will restore all configuration settings back to the
to Factory factory default settings. Any settings that have not been
Default saved will be lost, including any rules that you have created.
Settings: If you want to save your current configuration settings, use
the Save button above.
Note:.Restoring the factory default settings will not reset the
Wi-Fi Protected Status to Not Configured.
Reboot the Click the Reboot button to reboot the repeater.
Device:
Remove If you have previously installed a Language Pack, you can
Language
remove it by clicking the Remove button.
Pack:
D-Link DIR-505 User Manual

System

108