Basic Functions; Answering A Call; Answering A Call Via The Handset - Siemens HiPath 500 User Manual

Basic functions

Step by Step
+
18
Basic functions
Please read the introductory chapter "Getting to
know your OpenStage phone"
fully before performing any of the steps descri-
bed here on your phone.

Answering a call

Special default ring signaling is set for your telephone:
• When you receive an internal call, your telephone
rings once every four seconds (single-tone se-
quence).
• When you receive an external call, your telephone
rings twice in rapid succession every four seconds
(dual-tone sequence).
• When you receive a call from the entrance telepho-
ne, your telephone rings three times in rapid suc-
cession every four seconds (triple-tone sequence).
• If a call is waiting, you hear a short tone (beep) every
six seconds.
Your service personnel can adjust the ring ca-
dence for external and internal calls for you.
In other words, different ring cadences can be
set for different internal callers.
The number or the name of the caller appears on the
display.

Answering a call via the handset

The phone is ringing. The caller appears on the screen.
^
Lift the handset.
-
or
Raise or lower the volume. Keep pressing the key until
the desired volume is set.
page 10 care-