Miele Freezer Operating And Installation Instructions page 86

Installation
^ Remove the rear cover.
^ Loosen the level sensors and
carefully bend them upwards.
^ Remove the drip tray. If necessary
use a screwdriver to gently lever it
out.
86
Once the drip tray has been removed
you can align the position of the ice/
water dispenser using the four metal
strips.
^ Loosen the screws in the four metal
strips.
^ Then insert a screwdriver into one of
the four slits and push the ice/water
dispenser sideways until it is
correctly aligned with the furniture
front. The grey arrow indicates
alignment to the rear and the black
arrow shows the alignment to the
front.
^ Tighten the screws in the four metal
strips.
^ Replace the drip tray and clip the
level sensors back into position.
^ Refit the rear cover and the locking
device and then screw the rear cover
back on.
^ Replace the grille and the drip tray
cover.
^ Replace the dispenser spout.