Installation - Panasonic BL-PA100KT Getting Started

Installation

Connect the master adaptor (indicated by the
1
MASTER seal) to the wall outlet using the
included AC cord.
To wall outlet
Connect the terminal adaptor to the wall outlet
3
using the included AC cord.
To wall outlet
Confirm that the indicators on the master adaptor
5
are lit (not flashing) as shown.
PLC (blue)
LAN (green)
MASTER (green)
If the indicators are not lit as shown above, confirm all
connections and refer to the Troubleshooting section of the
Operating Instructions.
For best results
We recommend connecting the adaptors directly to a wall outlet. Avoid connecting high power-consuming appliances to the same
wall outlet. Additionally, connecting an adaptor to a uninterruptible power supply (UPS) or backup power supply device is not
recommended.
While connecting the adaptors to a wall outlet is recommended, keep the following in mind if you must connect an adaptor to a
power strip:
- Make sure the power strip does not a have a noise filter or a surge protector, as these features may interfere with the
performance of your adaptors.
- Do not connect the adaptor to a power strip that receives power from another power strip.
- Use a power strip with an AC cord that is as short as possible.
For more information, refer to the included Operating Instructions (found on the CD-ROM).
Connect the master adaptor to a network device
2
using a LAN cable (sold separately). We
recommend connecting the master to your router.
Router
Connect the terminal adaptor to a network
4
device, such as your PC, using a LAN cable (sold
separately).
Confirm that the indicators on the terminal
6
adaptor are lit (not flashing) as shown.
PLC (blue)
LAN (green)
MASTER (off)
If the indicators are not lit as shown above, confirm all
connections and refer to the Troubleshooting section of the
Operating Instructions.