Connecting The Ac Adaptor For The Cradle-Type Battery Charger - Casio IT-3000 Series User Manual

Using the Cradle-type Battery Charger (HA-B30CHG)

Connecting the AC Adaptor for the Cradle-type Battery Charger

Use the dedicated AC adaptor for the Cradle-type Battery Charger to connect to a wall outlet.
1. After making sure that the Cradle-type
Battery Charger power switch is turned
off, plug the AC adaptor into the AC
adaptor jack on the back of the charger.
2. Next, after connecting the power cable
to the AC adaptor, plug the AC adaptor
into a power outlet.
3. Turn on the power. This causes the
Cradle-type Battery Charger power
indicator lamp to light red.
4. Making sure that their power contacts come into contact with each other, place the
Handheld Printer Terminal onto the Cradle-type Battery Charger. This causes the
Cradle-type Battery Charger power indicator lamp to light green.
When charging is initiated, Indicator 1 (left side) on the Handheld Printer Terminal
lights red. When charging has been completed, it changes the color from red to green.
* The indicator may light even if the battery pack is not installed. Make sure that the
battery pack is installed in the Handheld Printer Terminal when charging.
Important !
• Take care to avoid allowing the Cradle-type Battery Charger power contacts to
make contact with each other since this can cause a short.
Shorting the power contacts can damage the Cradle-type Battery Charger.
• If you print while charging, the battery will wear down since the amount of
power discharged is greater than the amount of power supplied. Consequently,
you may not be able to print if the battery power is excessively low.
E-62
IT-3000_E_P53_81.p65
Power contacts
62
Power switch (OFF)
Power Indicator Lamp
POWER
Power switch (ON)
2005.3.29, 5:56 PM