Battery; Specification; Charging - Siemens S25 Service Manual

Mobile phones
Hide thumbs Also See for S25:
Table of Contents

Advertisement

7

Battery

7.1

Specification

The standard battery of S25 is of a Li-Ion type with a
voltage of 3.6Volts and a capacity of 650mAh.
There are four contact pads on the bottom side of the
battery pack for supplying the phone, measuring the
cell temperature and examining the battery type.
7.2

Charging

The battery can only be charged if inserted into the telephone. The charging process is
completely controlled by the mobile. Different kinds of Siemens chargers out of the accessory
program for S25 models (also refer to chapter „Accessories") can be used for this task:
 Rapid charger
 Desk top charger
 Travel charger
 Car charger
Attention:
Charging the battery can be impossible, if temperature of battery and/or
environment is too high or too low (e.g. (e.g. in car use during summer, or outside
during winter time). This is to prevent the battery from being damaged during fast
charge process. To enable the charging process again, battery and phone only
need to cool down/warm up. A replacement of battery is not necessary.
Service Manual S25 / S2588
Sm_S25_lvl2_v11.doc
Information and Communication Products
V 1.0
Page 25 of 35
Mobile Phones
ICP CD ST
R. Fleuren
06/99

Advertisement

Table of Contents
loading

This manual is also suitable for:

S2588

Table of Contents