Table of Contents
Advertisement
Supervising and controlling by computer
With a proper LAN cable connection and LAN Control settings, you can operate the projector from a computer using
a web browser when the computer and the projector are connected to the same local area network.
This projector supports Crestron
An example of connecting the projector to computer.
Computer
•
When using an external hub or router, use a Category 5 straight cable. (A crossed cable can be used with some hubs and
routers. See the appropriate documentation for more information.)
•
Don't touch the metal parts of the LAN connector and LAN cable because static electricity may be discharged from your
body, causing damage to the projector.
Configuring the LAN Control Settings
If you are in a DHCP environment:
1.
Make sure the projector and your computer are properly connected to the same local area network.
2.
Press MENU/EXIT and then press
3.
Press
displayed.
4.
Press
5.
Press
6.
Press
7.
Please wait for around 15 - 20 seconds, and then re-enter the LAN Control Settings page.
8.
The IP Address, Subnet Mask, Default Gateway, and DNS Server settings will be displayed. Note down the
IP address displayed in the IP Address row.
•
If the IP Address still does not appear, contact your network administrator.
•
If the LAN cables are not properly connected, the IP Address, Subnet Mask, Default Gateway, and DNS Server settings will
display 0.0.0.0. Make sure the LAN cables are properly connected and perform the above procedures again.
If you are in a non-DHCP environment:
1.
Repeat steps 1-4 above.
2.
Press
3.
Contact your network administrator for information on the IP Address, Subnet Mask, Default Gateway, and
DNS Server settings.
4.
Press
5.
Press
6.
To save the setting, press MODE/ENTER. If you do not want to save the setting, press MENU/EXIT.
7.
Press
If the LAN cables are not properly connected, the IP Address, Subnet Mask, Default Gateway, and DNS Server settings will
display 0.0.0.0. Make sure the LAN cables are properly connected and perform the above procedures again.
EN-34
Downloaded From projector-manual.com Mitsubishi Manuals
®
software.
to highlight LAN Control Settings and press MODE/ENTER. The LAN Control Settings page is
to highlight Control By and press
to highlight DHCP and press
to highlight Apply and press MODE/ENTER.
to highlight DHCP and press
to select the item you want to modify and press MODE/ENTER.
/
to move the cursor and then press
to highlight Apply and press MODE/ENTER.
External hub
LAN cable (option)
(100BASE-TX or 10BASE-T should be supported.)
/
until the SYSTEM SETUP: Advanced menu is highlighted.
/
to select LAN.
/
to select On.
/
to select Off.
/
to enter the value.
Advertisement
Table of Contents
