Connecting The Machine To The Power Source; Connecting The Machine - ELNA Carina Instruction Manual

Connecting the machine to the power source

Caution: Always make sure that the machine is unplugged from power source and the main switch is
on ("O"). when the machine is not in use and before inserting or removing parts.

Connecting the machine

Before connecting the power supply, make sure that the voltage and frequency shown on the machine is
conforming with your electrical power.
Place the machine on a stable table.
1. Connect the power line cord to the machine by inserting the 2-hole plug into the terminal box.
2. Connect the power line plug to the electric outlet.
3. Turn on the power switch.
4. The sewing lamp will light up when the switch is turned on.
To disconnect, turn the power switch to the off position, then remove plug from outlet.
Polarized plug information
This appliance has a polarized plug (one blade wider than the other), to reduce
the risk of electrical shock; this plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not modify the plug in any way.
3
ON
OFF