Using Your Infrared Sear Burner; Turn Gas Supply On - KitchenAid KBSU487TSS Installation Instructions And Use & Care Manual

Turn the Gas Supply On
1. For outdoor grills using gas supply source other than 20 lb LP
gas fuel tank:
Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
2. For outdoor grills using a 20 lb LP gas fuel tank:
Slowly open the tank valve.
NOTE: If flow limiting device activates, your grill may not
light. If your grill does light, the flames will be low and will not
heat properly. Turn tank valve and all control knobs off and
wait 30 seconds. After shutting off the tank, very slowly open
tank valve and wait 5 seconds before lighting.
Lighting the Grill and Infrared Sear Burner
IMPORTANT: If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.
1. Do not lean over the grill.
2. Select the burner you want to light. Push in and turn the grill
burner control knob to LITE/HI, while continuing to hold it in.
3. Surface Ignition Type Burners:
You will see the igniter glow. When burner is lit, release the
knob. Turn knob to desired setting.
Spark Ignition Type Burners:
You will hear the "snapping" sound of the spark. When burner
is lit, release the knob. Turn knob to desired setting.
4. Repeat for each of the other burners as needed.
Manually Lighting Main Grill and Infrared Sear Burners
1. Do not lean over the grill.
2. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
Right-hand side flange
3. Strike the match to light it.
16
4. Guide the lit match between the grill grate and one of the
B
5. Push in and turn the burner knob to LITE/HI for the burner
6. Repeat steps 2 through 5 for each main burner.
7. Remove match and replace manual lighting extension inside
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to light them manually,
contact the KitchenAid Customer eXperience Center. See the
"Assistance or Service" section.
Infrared grilling produces intense heat which quickly sears the
meat. Searing locks in flavor and juices while allowing the outer
surface to absorb smoke and food aroma that is produced as
grease and drippings are vaporized by the burner. The result is a
crisp, flavorful outside with a tender, juicy inside.
slots in the sear plate.
closest to the lit match. The burner will light immediately.
When burner is lit, turn knob to desired setting.
the cabinet drawer.

Using Your Infrared Sear Burner

(on some models)
Preheat the infrared sear burner for 5 minutes.
Ensure that meats are fully thawed and that all excess fat is
trimmed away prior to grilling.
Leave the burner set to HI when placing food on the grill to
sear.
Use the sear burner to sear meat 1 to 2 minutes on each side,
then move the meat to the main grill cooking surface to finish
grilling to the desired doneness.
NOTE: View is shown with grates removed. Grates are
to be in place when using the infrared sear burner.