Download  Print this page

KitchenAid KBGN274 Installation Instructions And Use And Care Manual page 8

27" (68.6 cm), 36" (91.4 cm), 39" (99.1 cm) and 48" (121.9 cm) outdoor grills
Hide thumbs

Advertisement

If converted to
Natural Gas
Natural Gas Use
This installation must conform with local
codes and ordinances**. In the absence of
local codes, installations must conform with
either the National Fuel Gas Code ANSI
Z223.1, or CAN/CGA-B149.1* Natural Gas
and Propane installation code.
WARNING
Explosion Hazard
Use a new AGA or CSA approved
"outdoor" gas supply line.
Securely tighten all gas connections.
Failure to do so can result in death,
explosion, or fire.
1.
Make gas connections.
A combination of pipe fittings must be
used to connect the grill to the existing
gas line.
• If local codes permit, use an outdoor
flexible stainless steel tubing gas
connector, design-certified by AGA or
CSA International, to connect the grill to
the rigid gas supply line. 5/8" diameter
line is recommended. Using a wrench to
tighten, connect the gas supply to the
grill. Use pipe joint compound on all non-
flared male threads. Do not kink or
damage the flexible connector when
moving the grill.
• Pipe-joint compounds suitable for use
with L.P. gas must be used. Do not use
Teflon
®
tape.
1/2" grill
rear of
gas pipe
grill
flexible gas
connector
8
2.
Open shutoff valve in the gas
supply line. The valve is open when the
handle is parallel to the gas pipe.
Test all connections by brushing on an
approved non-corrosive leak-detection
solution. Bubbles will show a leak. Correct
any leak found.
valve open
Copies of the standards listed may
be obtained from:
* CSA International
8501 East Pleasant Valley Rd.
Cleveland, Ohio 44131-5575
** for local codes, contact your local
building inspector
® Teflon is a registered trademark of E.I. Du Pont
de Nemours and Company.
valve closed

Advertisement

loading

  Related Manuals for KitchenAid KBGN274

This manual is also suitable for:

Kbgn292Kbgn364Kfgr270Kfgr274Kfgr292Kfgr364 ... Show all