Download  Print this page

Installation Instructions - KitchenAid KBGN274 Installation Instructions And Use And Care Manual

27" (68.6 cm), 36" (91.4 cm), 39" (99.1 cm) and 48" (121.9 cm) outdoor grills
Hide thumbs

Advertisement

Installation
Instructions —
Portable Outdoor
Grill
WARNING
Excessive Weight Hazard
Use two or more people to move
and install grill.
Failure to do so can result in back
or other injury.
1.
Move grill into desired outdoor
location.
2.
Open the hood.
3.
For models equipped with
rotisserie, remove the rotisserie's skewer
from the grill.
4.
For models with side burners.
Remove side burner cover from the top of
the carton that is located on the grill
grate. Remove bubble wrap from side
burner cover and set aside.
Open carton located on the grill grate.
Remove side burner grate, unwrap and
set aside.
Remove burners and burner caps from
carton and unwrap. Install each set of
burners and caps inside the side burner
cavity as shown.
notch
burner
cap
burner
alignment
Install side
burner grate
cover
extension
and cover
(with extension
toward grill)
burner
as shown.
grate
Properly dispose
of all packing
material.
5.
aside.
6.
7.
and warming shelf.
8.
sear plates are resting on pins.
tab
9.
L.P./propane gas tank.
Carefully lift off grill grates and set
Remove sear plates and set aside.
sear plate
Remove tiedowns from burners
warming
shelf
remove
tiedowns
remove
tiedowns
burner
Reinstall sear plates. Make sure
Open cabinet doors and remove
WARNING
Explosion Hazard
Securely tighten all gas connections.
If connected to LP, have a qualified
person make sure gas pressure does
not exceed 11" (28 cm) water column.
Examples of a qualified person
include:
licensed heating personnel,
authorized gas company personnel,
and
authorized service personnel.
Failure to do so can result in death,
explosion, or fire.
10.
Make gas connections.
L.P./propane
(supplied): The 20 lb. L.P.
tank is located in the compartment below
grill. Remove tank and take to an
authorized dealer to be filled. Reinstall
tank and screw the hose/ regulator
assembly to tank as shown.
The pressure
regulator and
hose assembly
supplied with
the grill must
be used.
Replacement
pressure
regulator and hose assembly specific to
your model, is available from your outdoor
grill dealer.
If converting to natural gas, see
conversion kit requirements and "Gas
supply requirements" section. Follow
instructions included with kit.
11.
Turn on the gas supply. Wait a
few minutes for gas to move through the
gas line.
pins
12.
Test all connections by brushing
on an approved non-corrosive leak-
detection solution. Bubbles will show a
leak. Correct any leak found.
13.
Go to "Checking and adjusting
the burners" section.
hose/regulator
assembly
7

Advertisement

loading

  Related Manuals for KitchenAid KBGN274

This manual is also suitable for:

Kbgn292Kbgn364Kfgr270Kfgr274Kfgr292Kfgr364 ... Show all