Bottom Sound Pad Installation; Complete Installation - KitchenAid W10275503B Installation Instructions Manual

Check side attachment
6
plastic
button
If securing with a side attachment, check that sides of door
do not rub against the screw heads. If they do, dishwasher
must be re-centered. When dishwasher is properly centered,
replace plastic buttons.
7
Remove towel and replace
lower dishwasher rack
Remove towel from dishwasher. Reinstall the lower dish
rack.
If needed, see website for animated representation
of this step. Visit www.kitchenaid.com/anchoring under
FAQ tab.
24

Bottom Sound Pad Installation

(on some models)
1. Remove the bottom sound pad from inside the
dishwasher and take it out of the plastic bag.
2. Place pad on the floor in front of the dishwasher,
making sure lettering is facing up and vinyl pad faces
down.
3. Fold up and hold the side panels down. Slowly slide
the pad toward the back of the dishwasher as far as it
will go, making sure not to push or pull any wires or
hoses. (Do not force.) Side panels will open to proper
position.
NOTE: If there are pipes or other obstructions coming
up through the floor, you will need to cut a slit in the
pad to fit around the obstacle.
4. Fold the front end of the pad up into position. Make
sure the vinyl pad is tucked up behind the door and
the dishwasher front legs, as shown.

Complete Installation

1 Reinstall access panels
Insulation
(on some models)
Access
panel
Lower
panel
Insulation
Grounding Gr Grounding ounding
clip clip clip