Cabinet Cutout Dimensions; Installation Instructions; Access Doors Care; General Cleaning - KitchenAid KBAL181T Installation Instructions And Use & Care Manual

Double Access Doors
27" (68.6 cm)
30" (76.2 cm)
36" (91.4 cm)
48" (121.9 cm)
1. Remove access doors from mounting frame by lifting each
door up and off the mounting frame hinge.
2. Install mounting frame flush to the face of the cabinet cutout.
Make sure the mounting frame is level.
IMPORTANT: Always follow label instructions on cleaning
products.
Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.
STAINLESS STEEL
Cleaning Method:
Rub in direction of grain to avoid damage.
Food spills should be cleaned as soon as possible. Spills may
cause permanent discoloration. Use stainless steel cleaner
and polish to clean spills.
KitchenAid ® Stainless Steel Cleaner and Polish Part Number
4396920 (not included) or KitchenAid
Part Number 8212510 (not included):
See "Assistance or Service" section to order.
Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
Vinegar for hard water spots
Use a glass cleaner to remove fingerprints.
4

Cabinet Cutout Dimensions

35½"
(90.2 cm)
A
Cutout Width
25 " (64.1 cm)
28 " (71.1 cm)
34 " (87.0 cm)
46 " (117.4 cm)

INSTALLATION INSTRUCTIONS

ACCESS DOORS CARE

General Cleaning

®
Stainless Steel Wipes
A
B
1 " (2.9 cm) min around
opening for mounting
optional doors or drawers
Single Access Door
18" (45.7 cm)
3. Install screws (not supplied) into holes located on the
mounting frame.
4. Replace access doors by placing each door back on the
mounting frame hinges.
To avoid damage to stainless steel surfaces, do not use soap-
filled scouring pads, abrasive cleaners, cleaners containing
chlorine, Cooktop Polishing Creme, steel-wool pads, gritty
washcloths or some paper towels.
EXTERIOR and INTERIOR
The quality of this material resists most stains and pitting,
providing that the surface is kept clean, covered and polished.
Cleaning Method:
Apply stainless steel polish to all areas before first use.
Apply after each cleaning to avoid damage.
Cleaning should always be followed by rinsing with clean,
warm water.
Use a metal polish or stainless steel brightener to remove
fingerprints, water spots, oxidation, and food stains. Always
follow the manufacturer's directions.
Wipe the surface completely dry with a soft cloth.
10 ¾"
(27.3 cm)
1 "
(3.8 cm)
20 "
(52.5 cm)
2 "
(6.8 cm)
B
Cutout Width
16 " (41.1 cm)