Alignment And Adjustment; Location Of Adjustment Button Of Remote Control - Samsung SV-627X Service Manual

2. Alignment and Adjustment

2-1 Reference
1) X-Point (Tracking center) adjustment, "Head switching adjustment" and "NVRAM option setting" can be adjusted with remote control.
2) When replacing the Micom (IC601) and NVRAM (IC605 ; EEPROM) be sure to adjust the "Head switching adjustment" and
"NVRAM option setting".
3) When replacing the cylinder ass'y, be sure to adjust the "X-Point" and "Head switching adjustment".
4) Among Samsung VCR remote control used for adjustment as a accessory, only the remote control that has figures buttons (0 ~ 9) is
available for all adjustment regardless of chassis.
5) How to adjustment.
- Press the "SW718 (TEST)" button on Main PCB to set the adjustment mode.
- If the corresponding adjustment button is pressed, the adjustment is performed automatically.
- If the adjustment is completed, be sure to turn the power off.

2-1-1 Location of adjustment button of remote control

X-Point (Tracking Center) Adjustment
NVRAM Option Setting
("MENU" Button)
Head Switching Adjustment
("SPEED" Button)
Samsung Electronics
VCR POWER
("5" Button)
CLR/RST
-/--
INPUT
REPEAT
<This type of remote control can adjust.>
Remote Control for adjustment is not supplied as a Service Jig.
TV POWER
SLOW
TV
SHUTTLE
VCR
V-LOCK
DISP./
F.ADV
VOL PROG/TRK
INDEX
OK
Fig. 2-1
POWER DISPLAY
CNT.RESET SPEED
TRK
IIP/S IPC
REC MENU
<This type of remote control can not adjust.>
2-1