ELECTRIC SAFETY INSTRUCTIONS
FOR POWER SUPPLY
In order to comply with the safety requirements set forth in
several international publications, the following measures
must be followed when using this unit:
1. The maximum room temperature around the power
supply must not exceed the one indicated on its label.
2. When connecting the unit to the electric supply and
to the equipment, respectively, you must check if the
voltage is the same indicated in the unit.
3. The consumption of the equipment connected to the
source output must not exceed the one indicated in the unit.
4. This product can be used for outdoor, just make sure
not make it wet.
5. If the power supply cable is damaged, it must be fixed
by the supplier, by its representative or by qualified
personnel to avoid danger.
6. If the unit was hit and it is noticed any damage in the
protection cover or failures, the unit must not be used
and must be fixed exclusively by technically qualified
personnel assigned by the product importer and/or
7. The equipment must be connected to a visible and
easy access socket.
8. This product is not a toy. It is not intended for use
by children under 8 years.
IMPORTANT SAFETY PRECAUTIONS
Note: There is a replaceable 10A glass fuse in the
cigarette lighter adapter. Replace a blown fuse by gently
unscrewing the tip of the lighter plug and inserting in a new
one of comparable Amperes rating. Do Not replace fuse
with a higher amp rated fuse.
f Do not immerse the cooler/warmer 12V plug in water.
f Do not insert foreign objects into the cooler/warmer
vent openings.The ventilation openings should not
be covered at any time while the cooler/warmer
f Do not use the cooler/warmer in the open air when it is
raining or snowing; it is not designed to be waterproof.
f Do not place cooler/warmer near heat sources:
heating vents, radiators, sunlight and/or any other
sources of heat.
f Do not use the cooler/heater in the presence of
flammable fumes or gases, such as propane.
f Do not use for cooking.
f Do not use for medical reasons or storage of medicine.
f Do not operate the cooler/warmer if it has received
a sharp blow, been dropped or otherwise damaged
in any way.
f Do not place liquids or foods in direct contact with this unit.
f Keep out of Reach of Children. The interior becomes
very hot or cold and could cause injury.
Labels on tool
Do not put electrical appliances inside the storage
compartment of the unit.
To avoid the electric shock, do not spill any liquid on the
surface of the unit when using. And do not disconnect plug
from outlet with wet hand.
Non-qualified people are not allowed to re-model, dismantle or
repair the unit prinately.
(For AC 120V type only) To reduce the risk of electric shock,
this unit has a polarized plug (one blade is wider than the
other). This plug will fit in a polarized outlet only one way. If still
does not fit, contact a qualitied electrician to install the proper
outlet. Do not change the plug in any way.
Attention! Do not Pull out the cord to disconnect the unit from
a wall outlet. hold the plug when disconnecting, pulling the
power cord may cause an electric shock.
Please disconnect the plug from the wall outlet when the unit
is not in use. Constant connection to the power source may
cause the isolator to age and may lead to electric shock or fire.
FEATURE (FIG. A)
1. Top Cover
2. Internal fan - Inlet
3. Internal fan -Outlet
4. Divider for separating storages
5. Extension puller
6. Ventilator - Inlet
7. Ventilator - Outlet
8. Carry Handle
9. Control Panel
10. Front feet
12. AC Power cord
13. 12V Power cord
14. AC socket
15. DC socket
16. AC/DC switch
17. Hot/Cold switch
18. Red Led indicating Hot
19. Green Led indicating Cold
20. Non-electric lid for optional (Only for AR)
f This appliance is not intended for use by persons
(including childrens) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
ENGLISH • 13
...... Class II