Drain Requirements
• A new drain hose is supplied with your dishwasher.
If this is not long enough, use a new drain hose with a
maximum length of 12’ (3.7 m) (Part Number 3385556)
that meets all current AHAM/IAPMO test standards, is
resistant to heat and detergent, and fits the 1” (2.5 cm)
drain connector of the dishwasher.
• Make sure to connect drain hose to waste tee or disposer
inlet above drain trap in house plumbing and 20”
(50.8 cm) minimum above the floor. It is recommended
that the drain hose either be looped up and securely
fastened to the underside of the counter, or be connected
to an air gap.
Use of air gap
Air gap
• Make sure to use an air gap if the drain hose is connected
to house plumbing lower than 20” (50.8 cm) above
subfloor or floor.
• Use 1/2” minimum I.D. drain line fittings.
• If required, the air gap should be installed in accordance
with the air gap installation instructions. When you are
connecting the air gap a rubber hose (not provided) will
be needed to connect to the waste tee or disposer inlet.
Water Supply Requirements
• A hot water line with 20-120 psi (138-862 kPa) water
pressure can be verified by a licensed plumber.
• 120°F (49°C) water at dishwasher.
• 3/8” O.D. copper tubing with compression fitting or
flexible braided water supply line (Part Number
4396897RP)
1/2” minimum plastic tubing is not recommended.
NOTE:
• A 90° elbow with 3/8” N.P.T. external pipe threads on one
end.
• Do not solder within 6” (15.2 cm) from water inlet valve.