Making Voip Settings; Using The Connection Assistant; Connection Assist - Siemens Gigaset S685 IP User Manual

Automatic firmware update
Your phone will check daily whether a
newer firmware update is available via the
Internet on the Siemens configuration
server. If this is the case, the message
firmware available is displayed when the
handset is in idle status and the message
key f flashes.
f
Press the message key.
Press the display key to con-
§Yes§
firm the prompt.
The firmware will be loaded onto your
phone.
Please note:
– If you reply to the prompt with §No§, the dis-
play will not be repeated.The message
will only be shown again if
firmware available
a newer version of the firmware than the
one rejected is available.
– You can deactivate the automatic version
check via the Web configurator (page 133).

Making VoIP settings

In order to be able to use VoIP, you must
set a few parameters for your phone.
New
You can make the following settings using
your handset.
u
Download the general access data for
your VoIP provider from the Siemens
configuration server and store them on
your phone.
u
Enter your personal access data for
your first VoIP account (first VoIP phone
number). You can configure the access
data for five further VoIP accounts via
the phone's Web configurator.
u
Set the phone's IP address in the LAN.
New
Please note:
You can set these and other parameters con-
veniently via the Web configurator on a PC
connected to your local network (see
page 110).
The connection assistant on your phone
can help you make the settings.

Using the connection assistant

The connection assistant starts automati-
cally when you set the handset and base
station up for the first time, or when you
try to connect to the Internet before mak-
ing the necessary settings.
You can also start the connection assistant
via the menu:
¢
v Ð

Connection Assist.

~
For how to enter VoIP settings using the
connection assistant, see page 16.
Making VoIP settings
¢
Telephony
Select and press
§OK§
Enter the system PIN and press
.
§OK§
.
99