Heat Pump Specifications - Amana ASZ 14 SEER Technical Manual

HEAT PUMP SPECIFICATIONS

ASZ140[18,30,36,38]1AA-AF; ASZ140241AA-AG; ASZ140[42,48,60]1AA-AE
Cooling Capacity, BTUH
Compressor
R.L. Amps
L.R. Amps
Low Pressure Switch
Open
Close
High Pressure Switch
Open
Close
Condenser Fan Motor
Horsepower
F.L. Amps
Liquid Line, Inches O.D.*
Suction Line, Inches O.D.*
Refrigerant Charge
Power Supply
(1)
Minimum Circuit Ampacity
(2)
Maximum Overcurrent Device
Electrical Conduit Size
Power Supply (Inches)
Approximate Shipping Weight
* Up to 24' in equivalent line length
(1) Wire size should be determined in accordance with National Electrical Codes; extensive wire runs will require larger wire sizes.
(2)
Maximum Overcurrent Protection Device: MUST use Time Delay Fuse or HACR type Circuit Breaker of the same size as noted.
NOTES:
• Always check the S & R plate for electrical data on the unit being installed.
• Installer will need to supply 7/8" to 1-1/8" adapters for suction line connections (4 & 5 ton units).
• Installer will need to supply 3/4" to 7/8" adapters for suction line connections (3 ton unit).
• Unit is charged with refrigerant for 15' of 3/8" liquid line. System charge must be adjusted per Installation Instructions Final Charge
Procedure.
• Installation of these units requires the specified TXV Kit to be installed on the indoor coil. THE SPECIFIED TXV IS DETERMINED BY THE
OUTDOOR UNIT, NOT THE INDOOR COIL.
NOTE: This data is provided as a guide, it is important to electrically connect the unit and properly size fuses/circuit breakers and
wires in accordance with all national and/or local electrical codes. Use copper wire only.
Unit specifications are subject to change without notice. ALWAYS refer to the units serial plate for the most up-to-date general
and electrical information.
18,000 24,000 30,000
9.0 12.8 14.1
48.0 58.3 73.0
22 PSIG 22 PSIG 22 PSIG
50 PSIG 50 PSIG 50 PSIG
610 PSIG 610 PSIG 610 PSIG
420 PSIG 420 PSIG 420 PSIG
1/12 1/6
0.6 0.9 1.1
3/8" 3/8" 3/8"
3/4" 3/4" 3/4"
143.0 173.0 188.0
208/230-60-1 208/230-60-1 208/230-60-1
11.8 16.9 18.7
20 20
1/2 or 3/4 1/2 or 3/4 1/2 or 3/4
191 201 203
36,000 36,000
16.7 14.10
79.0 77.0
22 PSIG 22 PSIG
50 PSIG 50 PSIG
610 PSIG 610 PSIG
420 PSIG 420 PSIG
1/6 1/4 1/6
1.5 1
3/8" 3/8"
7/8" 7/8"
213.0 211.0
208/230-60-1 208/230-60-1
22.4 18.60
30 30 30
1/2 or 3/4 1/2 or 3/4
242 242
42,000 48,000 60,000
17.9 19.9 26.4
112.0 109.0 134.0
22 PSIG 22 PSIG 22 PSIG
50 PSIG 50 PSIG 50 PSIG
610 PSIG 610 PSIG 610 PSIG
420 PSIG 420 PSIG 420 PSIG
1/4 1/4 1/4
1.5 1.5 1.5
3/8" 3/8" 3/8"
7/8" 7/8" 7/8"
213.0 273.0 278.0
208/230-60-1 208/230-60-1 208/230-60-1
23.9 26.4 34.5
40 40 60
1/2 or 3/4 1/2 or 3/4 1/2 or 3/4
268 300 314
5