4.4.1 Sample Procedure for Changing and Saving Values
This section contains an example of how to change and save values in Menu
Mode. Use the steps in Table 4–6 to perform the following tasks:
•
Enter Menu Mode
•
Change page offset values of X and Y in the LAYOUT menu
+0
0
10
:
:
from
to
•
Save the new values in NVRAM
•
Exit Menu Mode
Before You Begin
This example assumes that the printer is using the factory default values
in ROM. You will use Test Print A to verify the changes you make. Print a
copy of Test Print A before beginning this example (Section 2.13). Be sure
that all printing has stopped and the display reads 00 READY before you
make any changes.
Table 4–6: Changing and Saving Values
Operation
1. Press
to place the
On Line
printer off line.
— The On Line indicator
shuts off.
2. Press
to place the
Menu
printer in Menu Mode.
.
3. Press
once to scroll
the display to the
LAYOUT menu.
r
4. Press
to enter
Enter
the LAYOUT menu.
r
5. Press
to select
Enter
the offsetX feature.
0
Display Reads
00 READY
FONT/FEED LAYOUT
LAYOUT COPY/OVER
offsetX offsetY
offsetX =+0.0
Printer Configuration
4–11